Serving Vancouver, Burnaby, Richmond, the North Shore & the Lower Mainland

Technician applying a silicone sealant bead around a commercial window frame

Caulking & sealants · Greater Vancouver

Caulking & sealant replacement in Vancouver

Structural sealants, silicone and caulking for windows, doors, curtain wall and expansion joints — the first line of defence against water getting into your building.

  • Full cut-out and replacement, not caulk over caulk
  • Silicone, polyurethane and hybrid sealants matched to each joint
  • Photo-documented inspection of every elevation

100+ years

combined experience across our stone care and maintenance team

Master Certified

Trident paver & decorative concrete sealer contractor

Master Accredited

Stain-Proof applicator, with up to a 20-year sealer warranty

Full report

with photos on every property we service

Real project

A 4-storey Vancouver apartment building, sealed up again

Drag to compare. Along with cleaning and sealing the concrete, we epoxy-injected multiple large wall cracks that were causing leaks, replaced all of the building sealant and window-frame caulking, and restored and stained the yellow cedar window shutters.

Apartment building exterior with weathered shutters and failed sealant before restoration
The same apartment building after sealant replacement, crack injection and shutter restoration

Building envelope restoration — sealant and caulking replaced, cracks injected, concrete sealed, cedar restored.

Crew on a boom lift working on a commercial building envelope

Why it matters

Failed sealant is where most leaks start

Rain, UV and the constant expansion and contraction of a building break sealant down over time. Once a joint cracks, splits or pulls away from one side, water finds the gap — behind window frames, into wall assemblies and down to the floors below.

Replacing sealant at the right time is one of the least expensive ways to protect a building envelope. Left too long, the same joint can turn into rotted framing, stained interiors, mould and a far bigger repair bill.

Warning signs

Signs your sealant needs replacing

  • Cracking, splitting or crumbling joints
  • Sealant pulling away from the frame or wall
  • Hard, brittle or chalky caulking
  • Drafts, water stains or leaks around windows and doors
  • Gaps at expansion joints, flashings and penetrations

What we seal

Every joint on the building, inside and out

Window & door perimeters

Perimeter caulking between frames and cladding, concrete, brick or stucco — the most common source of envelope leaks.

Curtain wall & storefront glazing

Silicone weather seals on glazing systems and storefronts. Structural silicone glazing work follows the engineer’s or glazing manufacturer’s specification.

Expansion & control joints

Movement joints in concrete walls, parkades, balconies, plazas and sidewalks, sealed with traffic-grade and high-movement sealants.

Precast, panel & cladding joints

Joints between precast concrete, metal panels, EIFS and other cladding systems.

Flashings, copings & penetrations

Roof and wall penetrations, railings, vents, copings and flashings — the small details where water gets in.

Concrete crack repair

Epoxy injection and sealing of cracks in walls and slabs that are letting water through.

Interior silicone

Kitchens, bathrooms, showers, tubs and stone countertops — mould-resistant silicone, neatly finished.

Balconies & decks

Perimeter, railing post and drain joints on balconies and traffic decks, often paired with our epoxy traffic coatings.

Our process

Done properly, joint by joint

01

Inspect & map

We walk every elevation, photograph failed joints and note substrates, joint sizes and access needs.

02

Cut out old sealant

Old sealant is fully removed. New sealant doesn’t bond reliably to old caulking, so we don’t caulk over it.

03

Clean & prime

Joint faces are cleaned and primed where the manufacturer requires it, so the new sealant actually bonds.

04

Backer rod & profile

Closed-cell backer rod sets the correct depth and hourglass shape, so the joint can move without tearing.

05

Seal & tool

The right sealant for the joint, tooled for full contact and a clean, straight finish.

06

Report

A closing report with photos, so owners and strata councils have a record of what was done and where.

Choosing the right sealant

There is no single best caulking. We match the product to the joint, the substrate and how much the joint moves:

  • Silicone — excellent UV and weather resistance and high movement capability. The standard for glazing, curtain wall and metal.
  • Polyurethane — tough and paintable. Well suited to concrete, masonry and traffic-bearing joints in parkades and on decks.
  • Hybrid (MS polymer) — bonds to a wide range of materials, paintable and low odour. A good fit for many cladding and interior joints.

We follow each manufacturer’s requirements for joint size, primers and cure times. For commercial and strata buildings we can phase the work by elevation and coordinate access with residents and tenants.

FAQ

Frequently asked questions

How often should exterior caulking be replaced?

It depends on the product, the sun and rain exposure, and how much the joint moves. We recommend inspecting exterior sealants every few years and replacing them as soon as you see cracking, splitting, hardening or sealant pulling away from either side of the joint.

Can you just caulk over the old sealant?

We don’t. New sealant won’t bond reliably to old, weathered caulking, so a caulk-over job tends to fail quickly. We cut out the old material, prepare the joint and install new sealant properly.

Do you work at height on commercial buildings?

Yes. We use lifts and access equipment to reach upper elevations, as pictured on this site, and plan the work around residents, tenants and traffic.

Can you fix the leak, not just the caulking?

Often the sealant is the cause, but not always. We inspect around the leak, repair cracks with epoxy injection where needed, and bring in licensed trades for anything outside our scope — with photos so you can see what we found.

Do you handle strata and multi-building projects?

Yes. We can scope a full building or complex, phase it over a season and provide reports for council. See our commercial & strata services.

Free estimate

Get a free caulking & sealant estimate

Tell us about the building and where you’re seeing problems. Photos of the joints help us price accurately — you can attach up to three.

  • We review your request and photos
  • We call or email to confirm details and book an assessment if needed
  • You receive a clear written quote — no obligation

Free, no-obligation estimate. We never share your details.